Lite6 Red Injection Moulded Fan Duct

In stock
Only 3 left

If you need to couple a 30mm fan to a 22.3mm cylinder then look no further! The beautiful Lite6 fan ducts are injection moulded out of translucent red polycarbonate. They are much harder wearing than printed parts and because they are manufactured to tighter tolerances they are significantly less prone to vibration. 

These are exactly the same geometry part as the E3D-v6 Blue fan duct, but red.

These ducts are not compatible with v5 HotEnds. 

This duct is available for download as an STL on Thingiverse. Thing #340312.

Genuine Reseller

E3D Genuine Reseller

More Information
Brand E3D
Write Your Own Review
You're reviewing:Lite6 Red Injection Moulded Fan Duct
Your Rating
Copyright © 2016-2019 makerdise™. All rights reserved.