v6 Injection Moulded Fan Duct

In stock

If you need to couple a 30mm fan to a 22.3mm cylinder then look no further! The beautiful new E3D v6 fan ducts are injection moulded out of translucent blue polycarbonate. They are much harder wearing than printed parts and because they are manufactured to tighter tolerances they are significantly less prone to vibration. 

These ducts are not compatible with v5 HotEnds. 

This duct is available for download as an STL on Thingiverse.

Genuine Reseller

E3D Genuine Reseller

More Information
Brand E3D
Write Your Own Review
You're reviewing:v6 Injection Moulded Fan Duct
Your Rating

Compatible with E3D V6 and Lite 6 Hot Ends. These ducts are not compatible with v5 HotEnds.

Copyright © 2016-2019 makerdise™. All rights reserved.